Rebar Straightening and Cutting Machine

1. Before use replenish lubricating oil or lubricant to each rotation spot (each class of once - twice).

2. Only have confirmed there is no revolution barrier, put through the power. Start machine after move the move handle to the neutral position to test the direction of the electrical machinery. Strictly prohibit reversing to prevent from damaging the parts.

3. Determined the specification of straightening block and haulage turn trough according to the steel bar diameter. There are three pairs of haulage wheel, with A, B two troughs. Before work install the haulage wheel according to the following method. Choose the specification of the haulage turn trough According to the diameter of the adjusting steel bar to make its end surface pastes directly with the shoulder tightly and lock the flank with two round nuts.

4. Choose the suitable operating speed according to the adjusting steel bar diameter.

5. Operate idly to test according to the choice operating speed and adjust the check link bolt on the check link(30) to the release lever meet the clutch block but cutter gear can’t reverse. (Attention: When change the steel bar speed, it should readjust check link. If it is too tight, block will not to arrive easily and the steel bar length error is big. In normal condition it should be about 30mm, and if it surpasses 50mm it should be adjusted according to the breakdown content. Too loose, the clutch will send out noise.) Adjust the nuts on two ends of lever fulcrum to keep the gap of clutch at about 2-3mm.

6. When fixing spacing switch frame position, it should guarantee the limit switch cam can move around freely If the cam is blocked there will be the continuous cutting phenomenon of steel bar.

7. Adjust the arrangement form of the straightening block according to the steel bar diameter. Straighten and interrupt the steel bar about 1 meter in advance, and then contract the steel bar passed through straightening tube and haulage wheel. Afterwards adjust the three straightening blocks among the straightening tube. The great curve means inadequate eccentric quantity while slight for extremely big.

8. Pass one of the ends of steel bar though the straightening block the round hole in the center of straightening tube by the way of guiding tube. After the end of steel bar was blocked by the up and below haulage wheels, press down the start button and the machine start to straighten and cut off the steel bar automatically and stopped until press down the pause button.